Fluke 8846A 6.5 Digit Precision Multimeter with 0.0024% DC Accuracy and 10A Current Range

Input connectors for Volts, 2-wire Ohms, Hz, Period, Temperature, and Capacitance measurements. Input connectors source current for 4-wire Ohms measurements. All measurements use the Input LO connector as a common input. The LO input is isolated, and may be safely floated up to 1000 V above earth ground regardless of the measurement type. 1000 V is the maximum voltage rating between the Input HI and LO connectors and between each HI and LO input and earth ground.

Sense connectors sense the voltage across the unknown resistance for 4-wire Ohms measurements or provide the DCV reference Input for DCV Ratio measurements.

Soft keys are used to select various menu options while navigating the Meter's menus. Each soft key's function is identified with a label in the bottom row of the display. Keys without a label above them are inactive.

Accesses internal and external memory containing meter setups and measurements.

Connection for optional memory device to store meter readings.

Turns off the display. While in standby, the Meter will not respond to remote or front-panel commands. When taken out of standby, the Meter sets itself to its power-up configuration.

Accesses communication interface selection and setup, remote command set, system settings, and meter reset.

Accesses resolution setting, trigger functions, temperature setup, dBm reference selection, continuity settings, and other measurement related parameters.

Triggers measurement when trigger is set to external triggering.

Accesses math functions, Statistics, TrendPlot, and Histogram.

Uses the present reading as an offset value to create relative readings.

Selects meter function between volts dc, volts ac, amp dc, amps ac, ohms, continuity, diode test, frequency, period, capacitance, and temperature.

Selects between manual and auto range mode. Also increases or decreases the range when in manual ranging mode.

Backs up one layer in the menu selection.

All front-panel input connectors, except 10 A, are available on the rear-panel of the Meter. These switches switch the Meter's input between them.

Input connectors for ac and dc current measurement functions.